Sjt Glumac-Senior
👍good - luckily that option
Translated from DutchOnly during Black Friday. Code BF26: 15% extra off everything.
Product information
Black stainless steel screws with a cross head. Thanks to the cross head, the screw does not sink into the PET felt, so the fixing stays tight and the screw head disappears neatly into the black felt.
Allow one bag of 12 screws per panel. For larger projects, the box of 100 screws is better value.
About this product
This set contains 12 black A2 stainless steel screws, 24 mm long, with a cross head: enough for one acoustic panel. You drive them between the slats through the PET felt into the wall. The black head disappears into the black felt, so you cannot see the screws once installed. Screws through the felt give a firmer fixing than adhesive alone.
The cross head stops the screw sinking into the PET felt. That keeps the fixing tight. Tighten until the head just disappears into the felt and no further, because then the screw pulls the felt in. Spread the twelve screws over the height of the panel.
You fix acoustic wall panels with High Tack mounting adhesive, with screws or with both. Adhesive is quick; allow half a tube per panel. Do line up properly straight away, though, because you can only correct while the adhesive has not yet bonded. If you choose both, order one set of screws per panel as well as the adhesive.
Each set is for one panel. The panels are 60 cm wide: divide the width of your wall by 60 and round up. Up to a wall height of 2.60 metres, one row of 260 x 60 cm panels is enough. A wall 1.80 metres wide then needs three panels, three sets and 36 screws. For a lot of panels the box of 100 is better value: enough for just over eight panels.
If you screw into brick or concrete, drill pilot holes first and fit wall plugs. So have a drill and wall plugs ready. Check beforehand with a cable and pipe detector whether there are pipes or wiring in the wall. Use a spirit level to check that each panel is straight before you screw.
Installation
Hold the panel against the wall and line it up with the marked line.
Check with the spirit level that the panel is straight.
Screw between the slats, through the felt and into the wall. Spread the screws over the height of the panel.
On a brick or concrete wall, drill pilot holes first and insert wall plugs.
Tighten the screws until the head just sinks into the felt. Do not tighten any further, or the felt will be pulled in.
Reviews
Based on 4 reviews
3,75
Goed
Based on 4 reviews
Sjt Glumac-Senior
👍good - luckily that option
Translated from DutchEduard Datema
Doesn't stand out after mounting
Translated from DutchNihad Dolovac Heel onprofessioneel komunikatie!
I didn't receive it?
Translated from DutchRon Intres
Great screw
Translated from DutchCustomer projects with our acoustic panels
The questions customers ask us most often about this product.
In the calculator with the acoustic panels, choose installation with screws. The calculator then adds one set of 12 per panel to your basket, alongside the panels.
No. End strips cannot take screws. You glue them with a thin mounting adhesive or sealant; High Tack is too thick for that. So you only allow one set per panel.
That is not what they are intended for. For composite cladding and the aluminium trims there is a separate box of 100 stainless steel screws: 4 mm diameter, 25 mm long, with a low dome head. Allow six per cladding panel and six per trim.
This is how this product reaches you, and how collection by appointment works.
The full returns policy is in our terms and conditions.